Advertise - LB 4WD Mods and Accessories
 4WD MODS
BILSTEIN SHOCK ABSORBER LONG-TERM TEST
We haven't been able to kill these dampers - September 2016

We fitted a test set of Bilsteins to the Outback Travel Australia LandCruiser 75 Series exactly 85,000km ago. Since then they’ve done five major bush trips at a full 3.5-tonnes GVM on some of the worst roads and tracks in the Outback.

Bilsteins have been our preferred shock absorber brand since we did a test of many different after-market dampers some years ago. The Bilstein mono-tubes performed better than any of the twin-tube shocks we tested.

For an explanation of the difference between mono-tube and twin-tube shock absorbers check out our Tech Torque story.         

Our 75 Series is fitted with after-market Kings Springs' leaves that have a 50mm lift over standard. In addition we have a pair of Polyair airbags on the rear and these are inflated to 30psi maximum when we slide our half-tonne Tray Tek camper on the back. These low-pressure airbags help preserve unladen ride height and wheel travel, without unduly stressing the chassis.

An all-leaf suspension doesn’t have car-like ride quality – far from it – but the Bilsteins soften the standard ride quality by virtue of much better ‘bump’ damping and more powerful ‘rebound’ damping than the standard shocks, or any after-market twin-tube shocks we’ve tested.

There’s a popular myth fostered by some misguided suspension ‘specialists’ that you don’t need much bump damping – just plenty of rebound damping – and ride quality will be good. This isn’t true. It’s important that a shock absorber controls both bump and rebound actions and we haven’t found any mainstream dampers that do a better job of that than Bilsteins.

Sure, you can buy full-race shock absorbers that do a better job, but be prepared to pay out at least a grand each for them. The Bilsteins we’ve been testing are around $220-$250 each.

Our LandCruiser, ‘Harry’, hit the 85,000km mark on the Bilsteins after our winter 2016 trip, so although the ride quality was as good as when they were originally fitted, we thought it was time to have them checked by the local distributors, Sydney Shock Absorbers.

The shocks came off and were checked individually on the company’s shock absorber dynamometer. We expected to see some evidence of performance fall-off through wear, but there was hardly any difference between the dyno traces for bump and rebound action when compared with brand new front and rear Bilsteins.

The only maintenance they needed was a set of new bushes!

The up-front cost of a set of Bilsteins may be more than for some other brands, but the payoff for us is obvious.

 




« Go Back

Banner - Hella Barhawk Animated